Siemens SINAMICS G120 Getting Started page 25

Factory setting of the CU240B-2
The factory setting of the terminals depends on whether the Control Unit has a PROFIBUS /
PROFINET interface.
Factory setting of the terminals for Control Units without
PROFIBUS interface
Fieldbus interface is not active.
Converter with Control Units CU230P-2; CU240B-2; CU240E-2
Getting Started, 04/2014, A5E32885834B AB
Factory setting of the terminals for Control Units with
PROFIBUS interface
The function of the fieldbus interface depends on DI 3.
Installing
3.3 Installing Control Unit
25