Setting Into Operation; Specifications - IMG STAGELINE TXS-895HSE Instruction Manual

2) Remove the cover (8) of the battery compart-
ment . This will allow access to the battery com-
partment (7) .
3) Insert two 1 .5 V batteries of size AA (R6) with
the positive and negative connections as indi-
cated in compartment .
4) Replace the cover .
Do not dispose of used batteries in the
household waste; always take them to
a special waste disposal, e . g . collection
container at your retailer .

5 Setting into Operation

1) Connect a headband microphone or a tie clip
microphone (e . g . the headband microphone
HSE-110 or the tie clip microphone ECM-402L)
to the mini XLR jack (3) .
2) To switch on the transmitter, set the sliding
switch (2) to ON .
The LED status indication (4) shows green to
indicate normal operation . If it shows red after
switch ing on or during operation, the inserted
batteries are almost discharged and must be
replaced .
3) Adjust the transmission channel: By means of
the small adjusting key supplied, turn the ro-
tary switch CHANNEL (5) in such a way that the
arrow points to the desired channel .
The 16 transmission channels are assigned
to the following transmission frequencies:
Channel Frequency
1 518 .750 MHz
2 519 .375 MHz
3 521 .125 MHz
4 522 .000 MHz
5 523 .250 MHz
6 524 .250 MHz
7 524 .875 MHz
8 526 .000 MHZ
Note: If other wireless transmission systems are op-
erated with this wireless system at the same time,
the radio frequencies of the individual systems should
be carefully matched to each other to prevent inter-
ference .
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
Channel Frequency
9 526 .875 MHz
10 528 .250 MHz
11 531 .250 MHz
12 532 .000 MHz
13 533 .625 MHz
14 534 .750 MHz
15 536 .250 MHZ
16 541 .750 MHZ
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
4) Switch on the receiver and set it to the same
channel see operating instructions of the
☞
receiver .
Switch on the audio unit (mixer or amplifier)
connected to the receiver .
5) Speak / sing into the microphone . The level of
the audio signal transmitted is indicated on the
receiver .
The volume level can be readjusted by
changing the sensitivity via the gain control (6) .
For turning the control use the supplied adjust-
ing key . Adjust the transmitter to the optimum
level . If the level is too high, the transmitter will
distort, then turn back the control (if necessary,
turn it to the left stop) . If the level is too low, a
poor signal-noise ratio will result, then advance
the control correspondingly .
6) After all adjustments have been made, put the
transmitter into the girdle bag again and secure
it with the velcro fastener against slipping out .
7) Fix the girdle bag with the velcro clip on its rear
side to your clothes .
8) To switch off the transmitter after operation, set
the sliding switch (2) to OFF .

6 Specifications

Type of unit: � � � � � � � � PLL multifrequency pocket
Radio frequency
range: � � � � � � � � � � � � � 518 – 542 MHz, divided into
Audio frequency range: 40 – 18 000 Hz
Frequency stability: � � � ±0�005 %
Transmitting power: � � � 10 mW (EIRP)
Ambient temperature: � 0 – 40 °C
Power supply: � � � � � � � two 1�5 V batteries
Operating time: � � � � � � > 30 h
Dimensions (w/o bag): 68 × 195 × 25 mm
Weight: � � � � � � � � � � � � 130 g
Microphone connection: mini XLR, 3 poles
1 = ground
2 = audio input
1 3
3 = operating voltage 5 V
2
for the microphone
Subject to technical modification .
transmitter
16 channels ( ☞ table)
of size AA (R6)
7