Operating Elements And Connections; Important Notes; Setting Into Operation - IMG STAGELINE 25.4690 Instruction Manual

All operating elements and connections described
GB
can be found on the fold-out page 3.
1

Operating Elements and Connections

1 Transmitting antenna
2 On / off switch
OFF
STDBY = sound muted
ON
3 Display to indicate
1. the channel group (GROUP 00 – 09)
2. the channel (CHANNEL 00 – 99)
3. the battery status
4 Sensor for the IR signals to set the channel
5 Jack (mini XLR, 3 poles, unbal.) to connect an elec-
tret microphone
6 Battery compartment cover
7 Belt clip
8 Control GAIN for the microphone signal
9 Battery compartment
2

Important Notes

The pocket transmitter corresponds to all relevant
directives of the EU and is therefore marked with
G
The pocket transmitter is suitable for indoor use only.
Protect it against dripping water and splash water,
high air humidity and heat (admissible ambient tem-
perature range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the pocket transmitter and
no liability for any resulting personal damage or
material damage will be accepted if the pocket trans-
mitter is used for other purposes than originally
intended, if it is not correctly operated, or if it is not
repaired in an expert way.
If the pocket transmitter is to be put out of
operation definitively, take it to a local recy-
cling plant for a disposal which is not harmful
to the environment.
6
3 Applications
To provide a wireless audio transmission system, com-
bine the multi-frequency pocket transmitter TXS-
606HSE with the following receivers from "img Stage
Line":
TXS-606 with 1 receiver unit
TXS-626 with 2 receiver units
TXS-646 with 4 receiver units
Set the transmission frequency on the receiver
(672.000 – 696.975 MHz, frequency spacing 25 kHz).
Then simply press a button and, via IR signal, the
pocket transmitter is matched to the channel selected
on the receiver (ACT function = automatic channel tar-
geting).
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare that
the pocket transmitter TXS-606HSE is in accordance
with the basic requirements and the other relevant
regulations of the directive 1999 / 5 / EC. The declara-
tion of conformity can be found on the Internet via the
MONACOR INTERNATIONAL home page
(www.imgstageline.com).
In the Federal Republic of Germany, a frequency
assignment (for which a charge is payable) is re quired
for the pocket transmitter. The forms and notes con-
cerning the registration of the transmitters can be found
.
on the Web site of the Bundesnetzagentur (Federal
Network Agency) under www.bundesnetzagentur.de.
In other countries, it is necessary to apply for a
corresponding approval. Prior to operating the pocket
transmitter outside Germany, please contact the
MONACOR subsidiary or the corresponding authori-
ties of the respective country.
4

Setting into Operation

4.1 Inserting the batteries
For operating the pocket transmitter, two 1.5 V batter-
ies of size AA are required.
G
Always insert (rechargeable) batteries of the same
type and always replace all of them.
G
If the pocket transmitter is not in use for a longer
period of time, always remove the batteries to pre-
vent damage due to battery leakage.