3 Applications
To provide a wireless audio transmission
system, combine the pocket transmitter
TXS-707HSE / -707LT with the following
receivers from IMG STAGELINE:
TXS-707 with 1 receiver unit
TXS-727 with 2 receiver units
Setting the transmission channel is most
convenient: Just set the channel at the
receiver; via an infrared signal from the
receiver, the transmitter will then be set
to the same channel.
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL
declare that the products TXS-707HSE
and TXS-707LT comply with the direc-
tive 2014 / 53 / EU. The EU declarations of
conformity are available on the Internet:
www.img-stageline.com
Restrictions or requirements apply in
the following countries:
CZ
IT
The regulations of the country where the
products are operated must always be
observed. Prior to operating the prod-
ucts, please contact the MONACOR sub-
sidiary or the corresponding authorities
of the respective country. Links to the
national authorities can be found via the
following Internet address:
EL
FI
FR
LT
MT
PL
www.cept.org
t ECC
t Topics
t Other spectrum topics:
SRD Regulations and indicative list
of equipment sub-classes
t EFIS and National Frequency Tables
4 Setting into Operation
4.1 Inserting the batteries
For operating the pocket transmitter,
two 1.5 V batteries of size AA are re-
quired.
•
Always insert (rechargeable) batteries
of the same type and always replace
all of them.
•
If the pocket transmitter is not used
for a longer period of time, always
remove the batteries to prevent dam-
age due to battery leakage.
To open the battery compartment (9),
press the arrow of the battery com-
partment cover (6) and push the cover
downwards. Insert the batteries, with
the positive and negative poles as in-
dicated in fig. 2, then replace the cover.
Never put batteries in the
household waste. Always
dispose of the batteries in
accordance with local reg-
ulations.
9