About The Indications In The Display - Sony HT-SL500 Operating Instructions Manual

About the indications in the display

1 2 3
;
DIGITAL DTS
SW
;
PRO LOGIC II
L F E
q; 9
A ; DIGITAL: Lights up when the receiver is
decoding signals recorded in the Dolby Digital
format.
B DTS: Lights up when DTS signals are input.
C SW: Lights up when the audio signal is output
from the SUB WOOFER jack.
D Playback channel indicators: The letters
(L, C, R, etc.) indicate the channels being
played back. The boxes around the letters vary
to show how the receiver downmixes the
source sound.
L (Front Left), R (Front Right), C (Center
(monaural)), SL (Surround Left), SR
(Surround Right), S (Surround (monaural or
the surround components obtained by Pro
Logic processing))
Example:
Recording format (Front /Surround): 3/2
Sound Field: A.F.D. AUTO
L
SL
E Tuner indicators: Lights up when using the
receiver to tune in radio stations, etc. See
pages 18–22 for tuner operations.
Note
"RDS" appears for models of area code CEL,
CEK only.
F D.RANGE: Lights up when dynamic range
compression is activated (page 27).
G COAX: Lights up when the source signal is a
digital signal being input through the COAX
terminal.
4
L C R
SL S SR
C R
SR
H OPT: Lights up when the source signal is a
digital signal being input through the OPT
terminal.
I LFE: Lights up when the disc being played
back contains the LFE (Low Frequency
Effect) channel and the LFE channel signal is
actually being reproduced.
J ; PRO LOGIC II: "; PRO LOGIC" lights
up when the receiver applies Pro Logic
processing to 2 channel signals in order to
output the center and surround channel
signals. "; PRO LOGIC II" lights up when
the Pro Logic II Movie/Music decoder is
activated.
Note
Dolby Pro Logic and Dolby Pro Logic II
decoding do not function for DTS format signals.
5
ST
MEMORY
MONO D.RANGE
RDS OPT COAX
8 7 6
23 GB