Nice D-Pro Action Series Instructions And Warnings For Installation And Use page 7

Connection
A: CONTROL UNIT POWER SUPPLY Cable
- NDCC2000, NDCC2100 (three-phase)
- NDCC2200 (single-phase)
B: MOTOR cable
C: Cable for FLASHING LIGHT with aerial
D: PHOTOCELL cable
E: KEY SWITCH cable
F: SPIRAL cable for safety edge
Note 1 – If the power cable exceeds the maximum allowed length, a cable with larger cross-section must be used
Note 2 – These two cables may be replaced by a single 4 x 0.5 mm
CAUTION! – The cables used must be suited to the type of environment of the installation site.
A
3
A
4
TABLE 1 - Technical specifications of electrical cables (Fig. 2)
Cable type
4 x 1 mm
2
3 x 0.75 mm
2
special cables for Nice gearmotors are on sale as
accessories.
for other brands, contact the motor manufacturer
2 x 1 mm (for 230 V AC flashing light)
2
RG58 type shielded cable (aerial)
4 x 0.5 mm
2
2 cables 2 x 0.25 mm
Nice spiral cable is available as an accessory
cable.
2
B
1
B
2
2
C
Maximum admissible length
5 m (note 1)
2 m (note 1)
5 - 7 - 11 m
10 m
10 m
10 m (note 2)
50 m