Varytec Giga Bar LED 240 RGB 30 Degrees User Manual page 36

Operating
DMX mode
Operating mode 'Slave'
Giga Bar LED 240 RGB 30°
36
LED bar
This setting is only relevant when the device is controlled via DMX.
Press [MODE] repeatedly until the display shows 'dxxx' . Press [SETUP]. With [UP] and [DOWN]
you can now select one of the following DMX operating modes:
n '2-ch' (two channels)
'3-ch' (three channels)
n
'5-ch' (five channels)
n
'24Ch' (twenty-four channels)
n
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [MODE].
This setting is only relevant if the device is serving as Slave in a Master / Slave configuration
and is not controlled via DMX.
Press [MODE] repeatedly until the display shows 'SLAv' .
Wait about 30 seconds until the display turns dark. Then the settings have been applied. To
return to the parent menu without making changes, press [MODE].