Set Page Format (Extended) Esc - Epson EP-4004 Programming Manual

5.1.11. Set page format (extended) ESC (c nL nH t1 t2 t3 t4 b1 b2 b3 b4
ESC (c nL nH t1 t2 t3 t4 b1 b2 b3 b4
[Name]
[Format]
[Range of Definition]
( t4*1000000H + t3*10000H + t2*100H + t1 ) < ( b4*1000000H + b3*10000H + b2*100H + b1 )
[Function]
[Initial State]
[Related Commands]
Revision: 1
Set page format(extended)
1BH, 28H, 63H, nL, nH, t1, t2, t3, t4, b1, b2, b3, b4
nL=08H, nH =00H
0<t1,t2,t3,t4,b1,b2,b3,b4<=255
0 <= ( t4*1000000H + t3*10000H + t2*100H + t1 ) <= 1FFFFFFFH
(defined unit)
0 <= ( b4*1000000H + b3*10000H + b2*100H + b1 ) <= 1FFFFFFFH
(defined unit)
1) The origin on the Y axis of the position management coordinate system is set to:
+ (t4*256*256*256 + t3*256*256 + t2*256 + t1) x (defined unit)
from the origin on the Y axis of the page management coordinate system.
The bottom margin is set at a position spaced in the positive direction to:
(b4*256*256*256 + b3*256*256 + b2*256 + b1) x (defined unit)
from the origin on the Y axis of the position management coordinate system.
2) The printing position in the Y direction is shifted to the origin of the position
management coordinate system. At this time, the origin on the X axis is not changed.
3) If the distance from the origin on the Y axis of the position management coordinate
system to the bottom margin position is greater than the page length, then this distance
from the origin on the Y axis to the bottom margin position is set as the new page length.
4) If the paper inserted for printing is cut sheet paper, then the distance from the top margin
position to the bottom margin position is set as the page length.
5) This command is only effective in graphics mode.
6) In the case that it received this command immediately after the paper is loaded, it moves
to the top margin location that was designated.
The top margin position is set to 8.382mm(0.33 inches) .
The bottom margin position is set to the page length.
The page length is set to 558.8mm(22 inches).
[Setting] Commands whose settings are affected by this command.
The set page length is changed by the ESC (C command.
[Setting] Commands that change the effects of this command.
The top margin and the bottom margin are set by the ESC commands.
The page length and the bottom margin position are returned to their initial states by the
ESC @ and the ESC (G commands.
[Operation] Commands whose functionality is affected by this command.
New page processing by the FF command is affected (the amount of movement is
changed).
New lines generated by the LF command which go outside the printable area are
affected.
Processing by the ESC (v command is affected.
Processing by the ESC (V command is affected.
[Operation] Commands that change the effects of this command.
The page management units are set by the ESC (U command.
Ver 2.00
[Setting]
2013/Feb/08
Page: 36