Table of Contents
Advertisement
5.1.8. Set page length in defined unit (extended) ESC (C nL nH m1 m2 m3 m4
ESC (C nL nH m1 m2 m3 m4
[Name]
[Format]
[Range of Definition]
[Function]
[Initial State]
[Related Commands]
Revision: 1
Set page length in defined unit(extended)
1BH, 28H, 43H, nL, nH, m1, m2, m3, m4
nL=04H, nH=00H
0<=(m4*1000000H+m3*10000H+m2*100H+m1) *1440/(defined value) <=1FFFFFFFH
1)
The page length is set to ((mH x 256) + mL) x (page management value) *25.4mm.
2)
If the formula applied values of mH and mL produces a value outside the Range of
Definition, this command is ignored.
3)
The Y axis origin of the page management coordinate systems and position management
coordinate systems are set to the current Y direction printing position. The origin on the
X axis is not changed at this time.
4)
The top margin position is set to the origin on the Y axis. The bottom margin position
is set to the position positive Y page length from the top margin.
The page length is set to 558.8mm(22 inches).
[Setting] Commands whose settings are affected by this command.
The top and bottom margin position settings set by the ESC (c commands are cleared.
[Setting] Commands that change the effects of this command.
The page length, the page management value, and the top and bottom margin positions
are reset to their initial states by the ESC @ and ESC (G commands.
[Operation] Commands whose functionality is affected by this command.
New page processing by the FF command is affected (the amount of movement is
changed).
New lines generated by the LF command which go outside the printable area are
affected.
Processing by the ESC (v command is affected.
Processing by the ESC (V command is affected.
[Operation] Commands that change the effects of this command.
The page management value is set by the ESC (U command.
Ver 2.00
[Operation]
2013/Feb/08
Page: 33
Hide quick links:
Advertisement
Table of Contents
