Trouble Shooting; Table Of Contents - JPI JP-33 Service Manual

Technical Support
PART I -Trouble Shooting
Please refer to this trouble-shooting guide before contacting technical support. This guide
provides possible causes for the problems you are experiencing. Some simple checks or
minor adjustments on your part may eliminate the problems and restore proper operation.
To resolve a problem you will need to check the trouble-shooting table of contents to find the
problem or related problems. Once you have identified the problem you may need to use
one or more of the provided solutions to eliminate the problem. In the event you have tried
the remedies indicated but the problem is not solved; contact technical support as soon as
possible.

Table of Contents

1. General problems
1-1. Cannot insert film, or unit does not activate when film is inserted.
1-2. Unit continues to operate as if film is being processed (non-stop).
1-3. Scratch or marking on film.
a. White or black streaks parallel to film feed direction.
b. Scratches or markings on the film that are perpendicular to film feed direction and are
similar in size, distance and location.
c. Scratches or markings on the film that are not similar in size, distance or location.
1-4. Film Jam or lost film in processor.
1-5. Chemistry is not replenishing.
1-6. Replenishing rate is too high or too low.
1-7. Unit continuously replenishes.
1-8. Film is not dry.
1-9. During processing you hear squeaking.
2. Electrical problems
2-1. Unit does not turn on.
2-2. Circuit breaker continuously trips.
2-3. Unstable operation, the unit repeatedly runs and stops.
2-4. Display panel does not work.
2-5. Buzzer is not working
2-6. Main motor is not working.
2-7. Developer displayed temperature not the same as actual temperature.
2-8. Over or under supply of water.
2-9. Dryer heater does not work.
2-10. DEV heater overheats.
JP-33 SERVICE MANUAL
- -
14

- Trouble Shooting