Pixapro LED Series User Manual

PIXAPRO
Warning and Notes
1. The LECO1000B II is best used in a dry and well-ventilated environment.
2. Please DO NOT expose to rain or moisture, to avoid short-circuit.
3. Please DO NOT use with power-adapters not designed specifically with the LECO1000B II.
4. It's normal the LECO1000B II to get a little warm whilst in operation.
5. Please avoid any sudden shocks during transportation and/or installation, as impact damage
may cause deformation and damage to the light.
6. Please DO NOT look directly into the light whilst light is on.
7. Please DO NOT place the light near flammable substances, such as alcohol or gasoline or
other volatile solvents.
8. Please use the soft dry cloth to clean the light. You can wipe with a cloth with some neutral
detergent to remove difficult to remove stains, and then dry with a soft cloth.
9. Keep the light out of reach from children.
10. DO NOT attempt to repair light. If your LECO1000B II develops a fault, as doing so will
VOID your warranty. Please contact us at customerservice@essentialphoto.co.uk.
11. DO NOT dismantle the head unit unless work is carried out by a qualified technician.
Dismantling your LECO1000B II will VOID your warranty.
12. ENSURE the device is properly disconnected the power supply when the light is not in use,
before mounting or during maintenance
Note:The technical data are subject to change without notice.
Series LED User Guide
PIXAPRO