Simplicity Regent Hydro-Gear 0650 Series Service And Repair Manual page 82

7 Electrical System Service
Troubleshooting Flow Chart
Engine will turn over but will not start:
Check all wires and connec-
tions.
Component Tests OK
Check the the key switch.
Component Tests OK
Check the PTO switch.
Component Tests OK
Check the grey pedal
switch.
Component Tests OK
Check the seat switch.
Component Tests OK
Check the engine ignition
system.
Done
Engine runs for a few seconds then dies:
Check the key switch.
Component Tests OK
Check the fuel solenoid.
Done
Refer to A. Check / Clean
Wires and Connectors.
Refer to E. Key Switch
Tests.
Refer to F. PTO Switch
Test.
Refer to G. Foot Pedal
Switch Tests.
Refer to I. Seat Switch Test.
Refer to the Engine Manual.
Refer to E. Key Switch
Tests.
Refer to N. Fuel Solenoid
Test.
7 - 18
Component
Fails Test
Replace damaged wires
or connectors.
Component
Fails Test
Replace the key switch.
Component
Fails Test
Replace the PTO switch.
Component
Fails Test
Replace the pedal
switch.
Component
Fails Test
Replace the seat switch.
Component
Fails Test
Replace defective com-
ponents.
Component
Fails Test
Replace the key switch.
Component
Fails Test
Replace the fuel sole-
noid.