CYBEX 625T Owner's Manual page 18

Remove shield
1. Loosen but do not remove the two front cover screws securing the motor cover using a Phillips
screwdriver.
2. Remove motor cover by lifting vertically.
3. Loosen but do not remove the seven screws securing the shield to the base using a Phillips
screwdriver.
4. Remove shield by sliding sideways and then vertically off of base.
Route power cord
Decide whether you will plug the power cord into a power outlet near the front of the treadmill or the
back of the treadmill. Follow the corresponding routing procedure below. Do not plug the power cord
into a power outlet at this time.
Cybex 625T Treadmill Part Number LT-23221-4 H
Shock and electrocution hazard.
• Route power cord so it does not become damaged.
• Do not allow cord to be pinched or interfere with movement of treadmill.
Page 18 of 88
Description
1 Motor cover
2 Front cover
3 Screws
Description
1 Base
2 Screws
3 Shield
Qty.
1
1
2
Qty.
1
7
1