Connecting A Satellite Receiver - Sony WEGA KLV 21SR2 Operating Instructions Manual

Connecting a Satellite Receiver

Satellite receiver
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2
Using AUDIO and S VIDEO cables, connect the satellite receiver's AUDIO
and S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
3
Connect the supplied 75-ohm coaxial cable from your cable or antenna to the
TV's VHF/UHF jack.
75-ohm coaxial cable (supplied)
Satellite
antenna
cable
S VIDEO cable
(not supplied)
AUDIO cable
(not supplied)
Note
To watch the pictures input from the S VIDEO input jack, set "Auto YC" to "On" in the
(Setup) menu (See page 12).
Tips
• You can also use the VIDEO 2 IN jacks to connect your satellite receiver.
• If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
Installing and Connecting the TV
S VIDEO
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
Rear of TV
13