Basic Connections (Connecting Cable Tv Or An Antenna); Removing The Rear Cover; Attaching The Rear Cover; Connecting Directly To Cable Or An Antenna - Sony WEGA KLV 21SR2 Operating Instructions Manual

Installing and Connecting the TV
Basic Connections
(Connecting Cable TV or
an Antenna)
When connecting an antenna or cables, remove the
rear cover of the TV beforehand.

Removing the rear cover

1 Hold the lower right (or left) corner of the back
cover as illustrated below and pull it towards
you. Do the same to the remaining left (or right)
corner.
2 Hold the bottom edge of the cover with both
hands as illustrated and lift upwards.

Attaching the rear cover

Hold the rear cover as illustrated below, fitting the
four pegs on the rear cover into the corresponding
holes on the TV, then push the rear cover back onto
the TV.
8
Connecting directly to cable or an
antenna
VHF only or VHF/UHF or cable
75-ohm coaxial
cable (supplied)
Note
It is strongly recommended to connect the antenna using a 75-
ohm coaxial cable to get optimum picture quality. A 300-ohm
twin lead cable can be easily affected by radio noise and the like,
resulting in signal deterioration. If you use a 300-ohm twin lead
cable, keep it away as far as possible from the TV.

Cable box connections

Use this hookup if:
• You subscribe to a cable TV system that uses
scrambled or encoded signals requiring a cable
box to view all channels, and
• You do not intend to hook up any other audio or
video equipment to your TV.
1
Connect the coaxial connector from your cable
service to the cable box's IN jack.
2
Using the supplied 75-ohm coaxial cable,
connect the cable box's OUT jack to the TV's
VHF/UHF jack.
75-ohm coaxial
cable (supplied)
Cable
VHF/UHF
OUT
IN
Cable box
Also, set "Cable" to "On" in the
menu (See page 20).
Tips
• Your Sony remote control can be programmed to operate your
cable box (See "Programming the remote control" on page
30).
• To change channels using the cable box, set your TV to
channel 3 or 4 depending on the cable box channel output.
• If you will be controlling all channel selection through your
cable box, consider using the Channel Fix feature to set your
TV to channel 3 or 4 (See page 21).
Rear of TV
VHF/UHF
Rear of TV
(Channel)