Table of Contents
Advertisement
General
Problem
How to reset TV to
factory settings
How to restore Video settings
to factory settings
How to restore Audio settings
to factory settings
Cannot cycle through the other
video equipment connected to
the TV
Cannot operate Menu
Lost password
LED on the display unit is lit
100
Possible Remedies
s
Turn off the main power of the TV set. While holding down
remote control, turn on the main power of the TV set. Turn on the TV. While
RESET
holding down
receiver unit. (The TV will turn itself off, then back on again.) Release RESET.
s
Press
RESET
on the remote control while in the Video Menu (see page 78).
s
Press
RESET
on the remote control while in the Audio Menu (see page 80).
s
Video Label
Be sure the
s
If a menu option appears in gray, this indicates that the menu option is not
available.
s
In the password screen (see page 86), enter the following master password: 4357.
The master password clears your previous password; it cannot be used to
temporarily unblock channels.
s
The POWER ON/STAND BY LED (see page 16) lights up when the TV is turned
on. If the LED blinks continuously, this may indicate the TV needs a service.
s
The TIMER LED (see page 16) indicates that the timer is set. When the timer is
set, this LED will remain lit even when the TV is turned off.
on the remote control, press
Skip
option is not set to
RESET
on the
POWER
on the media
(see page 90).
Advertisement
Table of Contents
