Programming The Remote Control - Sony WEGA KE 42M1 Operating Instructions Manual

Programming the Remote Control

DVD/ SAT/
MUTING VCR CABLE
MODE
PICTURE WIDE SLEEP DISPLAY
FREEZE FAVORITES
TOP MENU
TV VIDEO 1/2/3 VIDEO 4 VIDEO 5
RESET PIC OFF MTS/SAP
GUIDE
14
5
POWER
3
4
MENU
F1
1, 2
F2
TV/SAT
1
The remote control is preset to operate Sony brand
video equipment.
Sony Equipment Programmable Code Number
DVD/VCR 701 (Sony Dream System)
SAT/Cable 801 (Satellite Cable Box)
If you have video equipment other than Sony brand
that you want to control with the TV's remote
control, use the following procedures to program the
remote control.
Note
The equipment must have infrared (IR) remote capability in
order to be used with this remote control.
From the "Manufacturer's codes" listed on page 15,
select the three-digit code number for the
manufacturer's code of your equipment. If more than
one code number is listed, try entering them one by
one until you come to the correct code for your
equipment. Use the code number to complete the
following procedure.
1
Press the DVD/VCR (FUNCTION) and RESET
buttons simultaneously, or press the SAT/
CABLE (FUNCTION) and RESET buttons
simultaneously.
2
Press the function button you want to program.
To program a cable box or a satellite receiver
Press SAT/CABLE (FUNCTION).
To program video equipment
Press DVD/VCR (FUNCTION).
3
Enter the three-digit manufacturer's code number
using the 0-9 buttons.
4
Press ENT (enter).
5
To check if the code number works, aim the
TV's remote control at the equipment and press
DVD/VCR and/or SAT/CABLE (POWER) that
corresponds with that equipment. If it responds,
the programming is completed. If not, try using
the other codes listed for that manufacturer.
Tips
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, you may not be able to operate your
equipment with the Sony remote control. In this case, use the
equipment's own remote control unit.