Programming the Remote Control
Your remote control can be programmed to use other equipment and is pre-programmed to operate
the following Sony equipment.
Function Button Sony Equipment Code Number
Programming Other Equipment
Confirm the Programming
If you can turn your equipment on and off using the green POWER button, the programming is
complete. If not, try the next code listed.
• In some cases, you may not be able to program your remote control. If this is the case, use your equipment's
own remote control.
• Any of the function buttons (DVD, AMP, STB) can be programmed to operate other equipment regardless of
the labeling. For example, if programmed with the correct code, a Blu-ray Disc player can be operated with
the DVD button. This is useful if your equipment does not match any of the labeled buttons.
To reset the remote control to the factory default:
Press SCENE, TV POWER, and
and TV) blink when successfully reset.
Follow the steps below to program your TV remote control.
1 Look for the code in the Manufacturer's Code List (refer to i-Manual) that
corresponds to the equipment you would like to operate with the Sony
remote control. If more than one code is provided, try programming the
first code listed. If your equipment's code is not listed, visit
http://esupport.sony.com/remotecodes for a more comprehensive list.
2 Press and hold a DVD, AMP or STB function button simultaneously with
INPUT button and release.
When in the programming mode, the function button (DVD, AMP, STB)
blinks for approximately 30 seconds until a code is entered.
3 Enter the five digit code using
(DVD, AMP, STB) are lit. If the code is not entered within 30 seconds,
you must repeat step 2.
or ENT to confirm the code. If successfully programmed, the
function button (DVD, AMP, STB) will blink twice, if not, it blinks five
simultaneously. The four function buttons (DVD, AMP, STB,
while the function buttons