Adjusting The Volume And Pan Of Zones - Kurzweil X-Pro Series Getting Started Manual

Adjusting The Volume And Pan Of Zones

You will likely want to adjust the volume of zones in a setup. You can also adjust the pan (left/
right speaker position) of each zone. Each parameter is easily controlled in the setup editor. For
more details of the parameters on this page see the PC3 Musician's Guide, Setup Mode Chapter,
The Pan/Volume (PAN/VOL) Page.
Let's look at the setup 38 Jazz Bass/Piano and adjust the volume and pan of zone 2 which
contains the piano program 8 Grand "Evans":
1.
2.
If you are not already in Setup mode, press the Exit button until you reach the ProgramMode page,
then press the Setup mode button, located with the mode buttons to the left of the display. This will
bring you to the Setup mode MAIN page. Next, with the setup 38 Jazz Bass/Piano selected in
setup mode, press the Edit button on the front panel. This will bring you to the CH/PROG page of
the setup editor (see below.)
From the CH/PROG page, press the PANVOL soft button on the bottom of the screen (see above.)
This brings you to the PAN-VOL page where you can view key and velocity ranges for the current
zone (see below.)
Step 2
Adjusting The Volume And Pan Of Zones
Setup Mode
4-9