Setting The Alarm Clock - Sangean RCR-29 Manual

Setting the alarm clock

There are two alarms which can each be set to wake you to AM / FM radio, or buzzer alarm. The
alarms may be set while the unit is off or while playing. Ensure that the time is set correctly before
setting the alarms.
NOTE
If no buttons are pressed for 10 seconds, the radio will exit the alarm setup.
1.
Press and hold the Alarm 1 button (for example) to enter the alarm 1 setting
2.
The hour setting of alarm 1 will begin to flash. Rotate the Tuning control knob to select the required
alarm hour, and press the Select button to confirm the setting. Rotate the Tuning control knob to
select the required alarm minute, and press the Select button to confirm the setting.
3.
Then the display will show the frequency options for the alarm. Rotate the Tuning control knob to
select the desired option and press the Select button to confirm the setting.
The alarm options are as follows:
ONCE – the alarm will sound once
DAILY – the alarm will sound everyday
WEEKDAY – the alarm will sound only on weekdays
WEEKEND – the alarm will sound only at weekends
4.
Rotate the Tuning control knob to choose the required alarm source (RADIO, BUZZER), and then
press the Select button to confirm the setting. If the alarm is set to the radio option, the radio alarm
will play the last listened radio station. The alarm has now been set. The Symbol for an active
alarm is shown on the display.
NOTE
Alarm radio can't be activated when the radio is enabled with the weather alert function. Buzzer
alarm will be activated instead.
5.
To quickly change the ON / OFF status of the alarm, press the corresponding alarm button (i.e.
Alarm 1 or Alarm 2 button), the "ALM ON" or "ALM OFF" will show on the display.
14