Sangean RCR-29 Manual page 11

Settings in menu
Settings are available in the menu. Menu settings can be done with the radio on or off.
Press and hold the Menu button until you hear a beep to enter the menu setting. Rotate the Tuning
control knob to cycle through CLOCK SET → JAN 1 MO (date format) → FM AUTO (FM auto (stereo) /
mono setting) → LOUD ON → USB OUT → SNOOZE 5 → 12 / 24H → FACTORY → FM 100kHz → AM
10kHz → FM 87-108 → VER P01 (Software version).
To exit the settings menu, press the back button.
CLOCK SET
When the display appears and flashes "CLOCK SET", press the Select button to enter the setting.
Rotate the Tuning control knob to select "MANUAL" or "RDS CT" (Clock Time).
A.
When choosing manual setting as the clock time setting of your radio, the RDS (Radio Data
System) function will be disabled. When the display appears and flashes "MANUAL", press the
Select button. The display will flash the hour digit, rotate the Tuning control knob to select the
required hour, press the Select button to confirm the hour setting. The display will flash the minute
digits, rotate the Tuning control knob to select the required minute then press the Select button to
confirm the real time clock setting. The year setting on the display will begin flashing. Follow the
steps above to set the year / month / day setting.
B.
When you set the clock time using the RDS function, your radio will synchronize its clock time
whenever it tunes to a radio station using RDS with CT signals. When the display appears and
flashes "RDS CT", press the Select button. To exit the settings menu, press the back button.
Turn on the radio and find an FM station with RDS CT service. The display will show the clock time
and RDS icon indicating the real time is auto set by RDS CT service. The radio clock time will be
valid for 2 days each time the radio time is synchronized with RDS CT.
NOTE
1.
If clock time from local RDS station is not correct, you should consider disabling the RDS CT
function.
2.
Please note that at times the RDS signal may broadcast the wrong time, this is the fault of the
radio station and not your radio.
JAN 1 MO (date format)
When the display appears and flashes a date (e.g. JAN 1 MO), press the Select button to enter the
setting. Rotate the Tuning control knob to select the required date format. Press the Select button to
confirm the setting.
10