Installation - Omnitronic MPVZ Series User Manual

Rear Panel
12
No. Element
12 Control PRIORITY
LEVEL
13 Inputs MIC 2 and
MIC 3
14 Inputs LINE 1 to 3
15 Output LINE
16 Zone outputs
17 Mains cable
18 Clamping screw
19 Direct speaker output
20 Mains fuse

4 Installation

This amplifier is built for 483 mm racks (19"). This rack should be a double-door rack where front panel and
rear panel can be opened. The rack should be provided with a cooling fan. When mounting the amplifier into
the rack, please make sure that there is enough space around the device so that the heated air can be
passed on. Steady overheating will damage your device.
You can fix the amplifier with four screws M6 in the rack. If several devices are to be installed, make sure
that you leave 1 unit (1 U) space between the devices. Be careful when mounting the amplifier into the rack.
Put the heaviest devices into the lower part of the rack. Be aware that fastening the amplifier with four
screws on the front panel is not enough. In order to ensure safety, additional fastening by using ground and
side bars is necessary.
If racks are to be transported or used for mobile use, fasten the devices additionally by connecting the rear
brackets with the side or ground bars of the rack. Thus, the amplifier cannot be pushed backwards. The front
panel alone is not designed to absorb acceleration forces occurring during transportation.
MIC 2 MIC 3
INPUT INPUT
ZONE 1
13 14 15
Function
Adjusts the attenuation level when releasing the chime and in case of
microphone announcements via microphone channel 1.
Unbalanced 6.3 mm jacks for connecting dynamic microphones.
Stereo RCA inputs for connecting units with line level (e.g. CD player).
Stereo RCA output for connection to units with line level inputs (e.g. mixer,
amplifier).
Terminals for zones 1 to 6 for connecting 100 V speakers.
For connection to a mains outlet.
For a potential ground connection.
• Direct output for 70 V or 100 V speakers or 4 to 16 Ω speakers and
common ground connection COM.
• The zone controls do not affect these outputs.
Only replace the fuse when the unit is disconnected from the mains. Only
use a fuse of the same rating and power. The correct fuse value is
specified on the rear panel.
19 20
DIRECT SPEAKER OUTPUT
100 V SPEAKER ZONES OUTPUT
ZONE 2 ZONE 3 ZONE 4 ZONE 5 ZONE 6
16 17
18 • EN
18