Controls - OSEE HCM-700 User Manual

Monitor Settings
Enable an output interface
2.
After setting the input source, it will be output to the two output interfaces: SDI
OUTPUT and HDMI OUTPUT. Whether you can get the signal source from the
SDI OUTPUT interface or the HDMI OUTPUT interface, it is determined by the
subitem setting of input outputOUTPUT.
 Enable SDI output interface: set input outputOUTPUTSDI as ON, as
shown in Figure 4.2-3, then you can get a signal source from the SDI
OUTPUT interface.
 Disable SDI output interface: set input outputOUTPUTSDI as OFF,
then there will be no signal output from the SDI OUTPUT interface.
The setting for HDMI output interface is as the same as the SDI's above, no
further description.
For example: if the signal source is set as HDMI, enable the SDI output and
disable the HDMI output, then, you can only get the HDMI image from the SDI
OUTPUT, but can't get anything from the HDMI OUTPUT.

4.2.2 Controls

The CONTROLS menu items are used to adjust volume, backlight, rotating image,
and set anamorphic ratio and image size from DSLR device. The menu items are as
shown in Figure 4.2-4:
Table 4.2-2 Description of Controls Menu Items
Figure 4.2-3 Enable SDI Output
Figure 4.2-4 Controls Menu
20