Table of Contents
Advertisement
Chapter 2 Unpack and Installation
Unpack:
When unpacking the HCM-700 monitor, please verify that none of the components
listed in Table 3.1 are damaged or missing. If there are any components missing,
please contact your distributors or OSEE for it.
Installation:
Prepare for installation
1.
Please follow the procedures below before installing HCM-700:
Check the package and equipment for any visible damage that may have
occurred during transit.
Confirm all the items listed on the packing list have been received.
Remove all the packing material including electrostatic-resistant packing.
Retain these packing materials for future use.
Connect required cables for signal input and output. For BNC
2.
connections use 75Ω rated connectors.
Connect the 11~17VDC power source using the included power supply or
3.
optional battery adapter and D-Tap to Power cable when not using Land
Line power.
As a final step, turn on the device by toggling the power switch located on
4.
the rear of the unit near the power jack.
Connect a standard signal line to the corresponding input port.
Please use the power adapter supplied for AC power.
Table 3-1 Packing List
No.
Item
1
HCM-700
2
Adapter
3
User Manual
4
Warranty Card
5
Certificate card
Quantity
1
1
1
1
1
5
Unpack and Installation
Advertisement
Table of Contents
