Appliance Dimensions - CDA FF881SC Installation, Use And Maintenance Manual

• The plug should be fully accessible at all
times.
• Ensure ventilation openings are kept
clear.
• Do not use a multi-plug adaptor in
the socket to connect this appliance
alongside other appliances.
• Do not tilt the freezer beyond 45º.
• Do not exert excessive pressure on the
appliance.
• Ensure that there is a gap of no less
than 10cm above and to the sides of
the appliance to allow for ventilation.
The clearance between the sides and
adjacent furniture must also allow the doors to open fully. Note
that a greater side gap will be required if the appliance is to be
positioned next to a wall to allow the doors to open fully.
• A gap of 7cm should be allowed for ventilation between the
rear wall and the back of the appliance. There is a plastic guide/
stopper supplied with the appliance
that should be fitted when aligning
the appliance with a wall. Place the
guide into the condenser and turn
it by 90° (Fig 6). The guide will then
lock into place. Take extreme care
not to damage the condenser whilst
doing this. The guide will protect the
condenser and ensure a minimum air
gap.
1860
595

Appliance dimensions

Fig. 5
Fig. 6
650 (700
with
handle)
17