Fault Codes; Installation And Ventilation - CDA FF881SC Installation, Use And Maintenance Manual

Fault codes

ERROR TYPE
SR Failure warnings
Freezer compartment is
LF
not cold enough
LP
"Low voltage" Warning
• A capital 'E' on the display merely indicates that Eco mode is
active. See page 11 for more information.
• The lower case 'e' on the display board is always on (except
when screen saver is active). THIS IS NOT A FAULT.
• A constant beeping and no cooling performance from the
appliance suggests a faulty door sensor. Contact Service.

Installation and ventilation

• When installing this product we recommend you seek the
help of another individual. This product may have some
sharp edges. Please take care and wear adequate PPE when
handling.
• This appliance must never be installed close to heat sources
such as heating elements, radiators, ovens and cookers nor
installed in damp places or direct sunlight.
• Failure to provide adequate ventilation can lead to increased
running costs and premature failure; it may also invalidate the
warranty provided with the product.
16
MEANING
Appears when one or
more of the freezer parts
fail or there is a problem
in the cooling system.
This warning especially
appears if there has
been a power failure
for a long period or
when the refrigerator is
time.
Freezers switches to
standby mode when
the voltage supply falls
below 170 Volts.
REASON
Call a service agent for assistance as
soon as possible.
1. Use food within a short time period.
Do not freeze food that has thawed.
2. Set the freezer temperature to colder
values or set to Super Freeze until
the compartment gets to normal
temperature.
3. Do not put fresh food in the appliance
until the fault has cleared.
4. Check the door closes and seals
properly (see previous pages).
This feature prevents the compressor
from damage due to low voltage. The
freezer will start operating automatically
when the voltage restores to the
required level.
REMEDY