Cisco Catalyst 5000 Series Manual page 29

Example Assumptions
Example Assumptions
For the example in the "Token Ring LANE Configuration Example," the following assumptions apply:
•
•
•
•
•
•
•
Configuring the TrCRF Example
To define the TrCRF, perform the following tasks:
SUMMARY STEPS
1. At the enable prompt, enter the following command:
2. To verify the configuration of the new VLAN, enter the show vlancommand.
DETAILED STEPS
Step 1
At the enable prompt, enter the following command:
Example:
Console> (enable) set vlan 112 name crf112 type trcrf ring 112 parent 400 mode srb
Step 2
To verify the configuration of the new VLAN, enter the show vlancommand.
The output indicates that crf112 has been added and that brf400 is its parent:
Example:
Console> (enable) show vlan 112
VLAN Name
---- -------------------------------- --------- ----------------------------
112 crf112
VLAN Type SAID
---- ----- ---------- ----- ------ ------ ------ ---- -------- ------ ------
112 trcrf 100112
VLAN AREHops STEHops Backup CRF
---- ------- ------- ----------
112 7
Console> (enable)
Catalyst 5000 series switches with the ATM modules installed are running ATM software Release
4.9b or later.
Catalyst 5000 series switch 1 runs the LES/BUS and LECS on interface atm0 and the LEC on
interface atm0.1.
Catalyst 5000 series switch 2 runs LEC on interface atm0.1.
The ATM module is installed in slot 4 of both Catalyst 5000 series switches.
You can change the ELAN name by entering the set vlan vlan_num [name vlan_name] command.
The ELAN on the switches is essentially a new TrCRF. The ELAN name is crf112 and the VLAN ID
is 112.
The parent TrBRF to the TrCRF 112 is brf400 (VLAN ID 400).
MTU Parent RingNo BrdgNo Stp
4472 400 0x112
7 off
Status Mod/Ports, Vlans
active
BrdgMode Trans1 Trans2
- - srb
Token Ring LANE Configuration Example
0 0
29