Cisco Catalyst 5000 Series Manual page 25

Configuring token ring lan emulation
Hide thumbs Also See for Catalyst 5000 Series:
Table of Contents

Advertisement

Configuring Redundant LANE Services
To configure the LES/BUS pairs, use the following commands beginning in privileged EXEC mode:
SUMMARY STEPS
1. ATM# configure terminal
2. ATM (config)# interface atm0
3. ATM (config-subif)# lane fssrp
4. ATM (config-subif)# interface atm 0. subinterface-number
5. ATM (config-subif)# lane server-bus tokenringelan-name
6. Repeat Steps 2 and 3 for all LES/BUSs you want to configure on this ATM module.
7. ATM (config-subif)# Ctrl-Z
8. ATM# show lane server
DETAILED STEPS
Command or Action
Step 1 ATM# configure terminal
Step 2 ATM (config)# interface atm0
Step 3 ATM (config-subif)# lane fssrp
Step 4 ATM (config-subif)# interface atm 0. subinterface-number Specifies the subinterface for the first ELAN.
Step 5 ATM (config-subif)# lane server-bus tokenringelan-name Enables the LES/BUS for an ELAN on the subinterface
Step 6 Repeat Steps 2 and 3 for all LES/BUSs you want to
configure on this ATM module.
Step 7 ATM (config-subif)# Ctrl-Z
Step 8 ATM# show lane server
Configuring Fast SSRP for Redundant LANE Services
Note
The LES/BUSs are not fully operational until one or more LECs are configured and the LECS database is
configured and bound to the ATM module interface.
This example shows how to specify the LES/BUS for an ELAN and verify the configuration:
ATM# configure terminal
Enter configuration commands, one per line.
ATM(config)# interface atm0.1
ATM(config-subif)# lane server-bus tokenring default
You must first configure the redundant LES/BUS pairs on subinterfaces for that ELAN.
You must then enter the ATM addresses of the redundant LES/BUS pairs into the LECS database for
the ELAN.
Configuring Fast SSRP for Redundant LANE Services
Purpose
Enters global configuration mode.
Specifies the major interface and enters subinterface
configuration mode.
Enables FSSRP on the major interface
(you cannot configure more than one LES/BUS per
subinterface).
Exits subinterface configuration mode.
Verifies the LES/BUS configuration.
End with CNTL/Z.
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ws-x5161Ws-5167Ws-x5162Ws-x5168

Table of Contents