Telephone Operation - Binatone SPIRIT 710 User Manual

Setting up continue...
8 Press UP or DOWN button to set the third
digit of the REMOTE ACCESS code.
9 Press MENU button to confirm the REMOTE
ACCESS setting.
10 Press EXIT button to return to standby mode.
TAM HD:
1 Press Menu button.
ON/OFF setting
The display shows
2 Press UP or DOWN button until display shows
T A M H D : O N
T A M H D : O N T A M H D : O N.
Press Menu button to confirm.
3
The ON will be blinking.
4
Press UP or DOWN button to select ON or OFF.
Press Menu button to confirm the TAM HD setting.
5
Note:If it is set to ON it will record up to 8 minutes
of messages.. If it is set to OFF it will record up to
20 minutes of messages,but the quality of the
recorded speech will not be as high.

5. Telephone Operation

The Ringer High-Low switch located at the back of the
Ringer volume
Base unit allows you to adjust the volume of the ringer.
- High volume
- Low volume
Lift the handset or press the SPEAKERPHONE
To make a button on the Base unit.
1
Check for dial tone.
call
2 Dial the telephone number.
The display shows the duration of the call in
minutes and seconds.
Using the Pre-dial mode
3
Dial the telephone number.
If you make a mistake you can correct it by using the DEL
button to delete digits and then adding the right ones.
4
Lift the Handset or press the SPEAKERPHONE
button on the Base unit to dial out the number.
Binatone Help Line - 0845 345 9677
Edited by Foxit PDF Editor
Copyright (c) by Foxit Software Company, 2004
For Evaluation Only.
.
OPTIONS MENU OPTIONS MENU OPTIONS MENU OPTIONS MENU
OPTIONS MENU
Calls are charged at Local Call rate.
11