Binatone Spirit 110 User Manual

Spirit 110
Corded Telephone

Unpacking your phone

In the box you will find:
• Base Unit
• Handset
• Coiled Handset cord
• Telephone line cord
for Base unit
• User manual
Keep the packing
materials in a safe
place in case you later
need to transport
the unit.
Keep your sales (till)
receipt, which is your
guarantee.
1. Where to find it
Ringer light - This flashes when the phone
1.
for an incoming call.
is ringing
2. M1,M2 and M3 one -Touch Memory Buttons
3. STO (Store)button
4. MEM button
5. LNR(Last Number Redial) button
6. Mute button
7. R(Recall) button
8. P(Pause) button
2. Installation
2. Installation
1. Locating the Base unit
The Base unit should be placed on a level surface, in a position where:
the telephone line cable will reach your telephone line socket or
extension socket.
it is not close to a sink, bath or shower, or anywhere else where
it might get wet.
it is not close to other electrical equipment - fridges, washing
machines, microwave ovens, TVs, fluorescent lights, etc.
2. Plug the coiled handset
cord into the Handset.
Plug the other end into
the jack on the left
side of the Base unit.
3. Place the Handset in
the Base unit.
1
2
3
4
5
6
7
4. Plug one end of the telephone line cord the jack at the back of the
8
base unit and the other end into modular wall jack.
5. Lift the Handset and check for Dial tone in the earpiece.

3. Telephone Operation

Making a
call
To answer a
call
To end a call
Last Number
Make sure the plugs
click into place. Redial
Mute
Always use the
Function
telephone line
cord supplied
with your
Spirit 110 phone.
Other telephone
line cords may
Use on PBX
not work.
to Modular
Wall jack
Telphone Operation continue...
Inserting a
Pause in
the dialing
sequence
Lift the Handset, listen for a dial tone.
1
2 Dial the telephone number you wish to call.
3 To end the call, return the Handset to the
Base unit.
Lift the handset to answer call.
Replace the Handset on the Base unit cradle.
Lift the Handset to redial the last number.
1
2 Press LNR button.
The phone automatically dials the last
number you called (maximum of 32 digits).
During a call press and hold the
button.
When the mouthpiece is muted, the person
at the other end of the call cannot hear you
but you can hear his side.
2 To get back to the call, release the
(MUTE) button.
If you are using your Spirit 110 phone on a
PBX,and the PBX user guide tells you to press
RECALL ;
Press R (RECALL) button on your
Spirit 110 phone.
For some switchboard system, an access
number must be dialed (usually an 8 or 9) to
get another dial tone and an outside line.
Pressing PAUSE button immediately after the
1
access number, a pause of about 3.6 seconds
will be entered, and the desired number can
be dialed immediately.
2 Press PAUSE button to insert a pause when
dialing or storing Long Distance Access Codes.
(MUTE)