Honda GP160H Manual page 90

dummyhead dummyhead
CYLINDER HEAD
REMOVAL/INSTALLATION
Set the piston at top dead center of the cylinder
compression stroke (page 3-7).
Remove the following:
– Fan cover (page 5-2)
– Carburetor (page 6-5)
– Control base (page 7-3)
– Muffler (page 11-2)
After installation, inspect following:
– Valve clearance (page 3-7)
– Cylinder compression (page 12-5)
CYLINDER HEAD COVER PACKING
CYLINDER HEAD COVER
HEAD COVER BOLT
(6 x 12 mm) (4)
BOLT (6 x 12 mm) (2)
CYLINDER HEAD BOLT (8 x 60 mm) (4)
24 N·m (2.4 kgf·m, 18 lbf·ft)
REMOVAL/INSTALLATION:
Loosen and tighten the bolts in a crisscross pattern in
2 – 3 steps.
SHROUD
CYLINDER HEAD GASKET
CYLINDER HEAD
DOWEL PIN (2)
CYLINDER HEAD
(Threads and seating surface)
12-3