Oil Level Switch Removal/Installation; Engine Stop Switch Removal/Installation - Honda GP160H Manual

dummyhead dummyhead
OTHER ELECTRICAL
OIL LEVEL SWITCH
OTHER ELECTRICAL
REMOVAL/INSTALLATION
Disconnect the oil level switch connector.
Remove the camshaft (page 13-4).
• Take care not to drop the valve lifter.
OIL LEVEL SWITCH JOINT NUT (10 mm)
10 N·m (1.0 kgf·m, 7 lbf·ft)
ENGINE STOP SWITCH
REMOVAL/INSTALLATION
• Remove the engine stop switch only if necessary for
engine stop switch or fan cover replacement.
Remove the fan cover (page 5-2).
Straighten the tab [1] of the engine stop switch [2] and
remove the engine stop switch.
Install the engine stop switch to the fan cover aligning
its groove with the boss of the fan cover.
Bend the tab until it is fully seated on the fan cover so
the engine stop switch is held.
• The tab is used for ground terminal.
Install the fan cover (page 5-2).
10-2
O-RING
OIL LEVEL SWITCH
BOLT (6 x 12 mm) (2)
Align
[1] [2]