Sony DCR-TRV75 Operating Instructions Manual page 86

Dubbing only desired scenes – Digital program editing (on tape)
Operation 2: Performing Digital program editing
(1) When you use a digital video camera recorder, set the power switch of VCR to
(2) Make sure your camcorder and the VCR are connected, and that the VCR is set
(3) Press FN to display PAGE1.
(4) Press MENU to display the menu.
(5) Select VIDEO EDIT in
(6) Select TAPE, then press EXEC.
(7) Press START.
(8) Press EXEC.
To cancel dubbing during editing
Press CANCEL.
To end Digital program editing
Your camcorder stops when the dubbing is complete. Then the display returns to
VIDEO EDIT in the menu settings.
Press
You cannot record on the VCR in the following
Indicator
No indicator
CHECK "i.LINK" & REC STATUS • i.LINK is selected but an i.LINK cable is not
When the program has not been set
You cannot press START.
86
(Dubbing the tape)
VCR/VTR.
to recording pause.
When you use an i.LINK cable the following procedure is not necessary.
Search for the beginning of the first program, then start dubbing.
The program mark flashes.
The SEARCH indicator appears during searching, and the EDITING indicator
appears during editing on the screen.
The program mark changes to light blue after the dubbing is complete.
When the dubbing ends, your camcorder and the VCR automatically stop.
END to end the video edit function.
, then press EXEC (p. 182).
Cause
• The write-protect tab on the cassette is set to lock.
• The IR SETUP code is not correct. (When IR is
selected.)
• The button to cancel recording pause is not
correct. (When IR is selected.)
connected.
• The power of the connected VCR is not turned
on. (When i.LINK is selected.)