Sony DCR-TRV75 Operating Instructions Manual page 82

Dubbing only desired scenes – Digital program editing (on tape)
When the VCR does not operate correctly
•After checking the code in "About the IR SETUP code" (p. 81), set the IR SETUP or the
PAUSEMODE again.
•Place your camcorder at least 30 cm (12 in.) away from the VCR.
•Refer to the operating instructions of your VCR.
Step 3: Adjusting the synchronization of the VCR
You can adjust the synchronization of your camcorder and the VCR.
Prepare a pen and paper for notes.
Before operation, eject the cassette from your camcorder (if inserted).
(1) Insert the recordable cassette into the VCR, then set the VCR to recording
(2) Select ADJ TEST, then press EXEC.
(3) Select EXECUTE, then press EXEC.
(4) Rewind the tape in the VCR, then start slow playback.
(5) Calculate the average of five opening number values of five IN, and the
(6) Select "CUT-IN," then press EXEC.
(7) Select the average number value of IN, then press EXEC.
(8) Select "CUT-OUT," then press EXEC.
(9) Select the average number value of OUT, then press EXEC.
(10) Press
82
pause.
When you select i.LINK in CONTROL, the recording pause is not necessary.
IN and OUT are recorded on an image for five times each to calculate the
number values for adjusting the synchronization.
The EXECUTING indicator flashes on the screen. When finished, the
indicator changes to COMPLETE.
Five IN numbers and corresponding OUT numbers are displayed.
Take a note of the opening number value of each IN and the closing number
value of each OUT.
average of all the closing number values of each OUT.
The calculated start position for recording is set.
The calculated stop position for recording is set.
RET. to execute.