I3.2.1 Detergent Dispenser Manual Activation; I3.2.2 Setting The Dispenser - Electrolux EGWSSIC Manual

Info
If changing to a different type of detergent rinse aid
(even the same brand), it is necessary to rinse the inlet
and outlet pipes with clean water before connecting
the new detergent/rinse aid container. Otherwise, the
mixing of different types of detergent/rinse causes a
crystallization, with possible breakage of the dosing
pump. Failure to observe this instruction will void the
warranty and relieve the manufacturer of any liability.
I3.2.1 Detergent dispenser manual activation
Whenever the detergent containers are replaced, it
may be necessary to activate the dispensers manually
in order to fill the hoses and eliminate any air.
Proceed as follows:
• Simultaneously press the buttons, as shown in the
figures below.
1 2 3
DETERGENT DISPENSER
• If necessary, repeat this operation several times.
I3.2.2 Setting the dispenser
All operations should be carried out with the appliance
switched on, the door open and no cycle selected.
LEGEND
Increase
Decrease
Confirm or select next parameter
SEQUENTIAL START
Press the indicated buttons simultaneously for 5 sec-
onds:
Display of programming mode:
GEn
Initial amount of detergent:
dln
Setting the activation time:
1
1 2 3
45
45
Amount of detergent during the cycle:
dEt
Setting the activation time:
8
Exit from programming mode:
Electrical connections for automatic dispensers.
The appliance has a terminal board for the power sup-
ply of dispensers operating at 230 V, max. power
30VA.
Connect to the terminal board "L" (B) to terminals 1
and 2 for dispensing during the rinse cycle or to termi-
nals 3 and 4 for dispensing during the wash cycle.
Notes for external dispensers:

- if the detergent dispenser only ope-
rates during wash pump operation; terminals 7-9
of the main terminal board are powered at the
same time.

- if the detergent dispenser only ope-
rates during filling electrovalve operation for
restoring the boiler level; terminals 7-9 of the main
terminal board are powered at the same time.
Example:
Supposing that an external detergent dispenser has
been connected with a tank concentration measuring
sensor, a standard setting could be as follows:

the dispenser is not activated during filling of
the tank.

the dispenser is activated during wash
pump operation and, thanks to the concentration
measured by the conduction sensor, the correct
amount of detergent is dispensed.
IMPORTANT
For connections, see the wiring diagram.
1 2 3
1 2 3

19