Maintenance By The Customer Service Department; Maintenance Tasks; Notes On Safety; Battery Safety Instructions - Kärcher KM 100 Operating Instructions Manual

Operating instructions
Maintenance by the
customer service
department
Maintenance after 20 operating
hours
First inspection
Maintenance every 100 operating
hours
Maintenance every 300 operating
hours
Note:
To safeguard warranty rights, during
the warranty period all service and
maintenance work must be
performed by an authorised Kärcher
after sales service.

Maintenance tasks

Notes on safety

Warning!
Preparations
! Stand sweeper on a flat surface
! Turn ignition key to "0" and
remove it
Danger!
— The engine takes approx. 3...4 s
to run down after being shut off.
! Never enter operating area
during this period!
! Allow the machine to adequately
cool down prior to all
maintenance and repair work
! Do not touch hot parts such as
the driving engine and exhaust
system.
Please do not allow engine oil,
fuel oil, diesel and petrol
to contaminate the environment.
Please protect the ground and
dispose of used oil ecologically.
KM 100/100 R D

Battery safety instructions

Danger!
Always heed safety precautions for
handling batteries!
Observe the operating instructions
Work on batteries is permitted only
after instruction by trained personnel
Danger!
! Wear safety goggles and
protective clothing
! Observe regulations for the
prevention of accidents as well
as DIN VDE 0510, VDE 0105 T.1
Danger!
Risk of fire and explosion!
— Smoking prohibited
— No naked flames, glowing
embers or sparks in the vicinity of
batteries
— Do not place any objects or tools
on the battery because voltage is
always present between the
battery poles
— Areas in which batteries are
charged must be well ventilated,
as highly explosive gas forms
during charging
Danger of acid burns!
! Rinse out or rinse off splashes of
acid in the eye or on the skin with
copious quantities of clean water
! Then consult a doctor
immediately
! Wash contaminated clothing with
water
Please dispose of batteries and
accumulators ecologically
Batteries and accumulators contain
substances that are not allowed to
contaminate the environment.
Please, therefore, dispose of them
in appropriate recycling systems.

Mount and connect battery

! Open unit cover, engage stay bar
! Place battery in the battery
mounting
! Screw mountings to bottom of
battery
! Connect battery terminal clip (red
wire) to positive terminal post (+)
! Connect battery-terminal clip to
negative terminal post (-)
Note:
When removing the battery care
must be taken to ensure that first
the negative terminal post lead is
disconnected.
Check that the battery poles and
pole connectors are protected
adequately with pole protecting
grease
English

Charge the battery

Danger!
! Always heed safety precautions
for handling batteries!
! It is essential to observe the
instructions provided by the
manufacturerer of the charging
unit
! Disconnect the batteries
! Connect positive terminal post
lead of the battery charger with
the battery's positive terminal
post connection
! Connect negative terminal post
lead of battery charger with the
battery's negative terminal post
connection
! Plug in power plug and switch on
charger
30