Carrier 42BC Series Technical Data Manual page 51

On HEAT mode the equipment brings the temperature up to the temperature you have set,
HEAT
between 18 and 30°C. Use the
optimum temperature. The HEAT option is available only in cooling and heating units.
3
On these buttons you can perform the desired TEMPERATURE SETTING,
between 18 and 30°C on the remote control display.
4
By pressing the FAN button you can select the desired FAN SPEED on the display.
LOW
Bear in mind that on the AUTOMATIC FAN SPEED mode, the fan speed will be selected
by the unit's electronic controller, seeking to meet your needs, based on the desired
TEMPERATURE SETTING.
5
This button don't have application on this units.
6
The CLOCK button sets the CURRENT TIME on the display. After it is pressed,
the digits on the display will start flashing. Press the HOUR and MIN buttons
to perform the settings. When you are finished, press the CLOCK button again
to confirm the new settings.
7
The START button sets the START TIME on the TIMER, indicating to the
electronic controller the scheduled time for the unit to start. After pressing
it, the digits on the display will be flashing. Press the HOUR and MIN buttons
to perform the settings. When you are finished, press START again to confirm
the new settings. If you wish to undo the settings, press the button again so
that the information will disappear from the display.
8
The STOP button sets the STOP TIME, indicating to the electronic controller
the scheduled time for the unit to stop. After pressing it, the digits on the display
will be flashing. Press the HOUR and MIN buttons to perform the settings.
When you are finished, press STOP again to confirm the new settings. If you
wish to undo the settings, press the button again so that the information will
disappear from the display.
9
By pressing the HOUR and MIN buttons you can set hour and minutes
respectively for the START TIME and STOP on the TIMER and CURRENT
TIME. For the TIMER's START TIME and STOP TIME the minutes will be set
for every 10 minutes.
When the function is enabled TIMER on the front panel of the
internal unit, illuminate the LED corresponding to the symbol
MED HIGH
(Medium)
CATÁLOGO TÉCNICO / DATOS TÉCNICOS / TECHNICAL DATA - CT 42B 60Hz
buttons to select what you consider to be the
(Automatic)
.
51