E-Collar Technologies 300TS User Manual

Hide thumbs Also See for 300TS:

You are using a top of the line product when it comes to remote training

with your dog. As you can see in the owner's manual for the Ecollar

Technologies 300TS collar, there are a lot of ways this collar can be used.

In this write up, I have described the settings that Paws and Possibilities

recommends for the most efficient training of your dog.

There are 3 programmable modes on this collar.

Yours is set on Continuous Mode- What that means is that when you

push the button down, your dog will feel the sensation of the stimulation

for as long as you hold the button down. There is a letter "C" displayed in

the LCD screen of the transmitter.

The black button labeled "S" is the main button you will push. It will send

a stimulation to the receiver for whatever level your collar is set on (the

number shown on the LCD screen).

The red button labeled "S" is the booster and will deliver a stimulation

level higher than the main button. The collar comes with the default

booster set to stimulate 20 levels higher than what it is set on. We often

find 20 levels is too high for the purposes of which we need and we can

manually set the booster to be whatever number higher will work best

for your dog. There are directions in the manual (that we have

highlighted) indicating how to change this number. Please do not change

the booster level with the collar on your dog.

The black button labeled "T" is for Tapping and causes the collar to

vibrate when it is pressed. There will only be certain circumstances

where we will recommend you use this feature.

Table of Contents

Need help?

Do you have a question about the 300TS and is the answer not in the manual?

Page 1 As you can see in the owner’s manual for the Ecollar Technologies 300TS collar, there are a lot of ways this collar can be used. In this write up, I have described the settings that Paws and Possibilities recommends for the most efficient training of your dog.
Page 2 A feature of this collar that often comes in handy when you are outside with your dog at night is the light. You can push the on/off button on the back of the transmitter and turn on a light on the receiver. It will cycle through strobe, continuous, and off depending on how many times you push the button.
Page 3 Yours collar is set on Continuous Mode. What that means is that when you push the button down, your dog will feel the sensation of the stimulation for as long as you hold the button down. There is a letter “C” displayed in the LCD screen of the transmitter. The areas highlighted in yellow below apply to the set up we are using with your collar.
Page 4 You will need to confirm that your trainer has changed the booster level so please check with her if you are not clear about this. If you ever need to change it yourself, these directions clearly explain the steps you’ll need to take.
Page 5 A feature of this collar that often comes in handy when you are outside with your dog at night is the light. You can push the on/off button on the back of the transmitter and turn on a light on the receiver. It will cycle through strobe, continuous, and off depending on how many times you push the button.