Do you have a question about the 1000 Series and is the answer not in the manual?
Questions and answers
John Lack
June 25, 2025
I received the collar and receiver for my 1000 series. I matched my new collar to my receiver. Status light is blue, lcd blinking dot. All is registering ok. No tone or shock to the collar. Is there some way I can reset
Subscribe to Our Youtube Channel
Related Manuals for E-Collar Technologies 1000 Series
Summary of Contents for E-Collar Technologies 1000 Series
Page 1
Contact Information E-Collar Technologies, Inc. 2120 Forrest Park Drive 1000 Series Garrett, IN 46738 Toll-Free 1-855-326-5527 Operation Manual Toll-Free Fax 1-855-226-5527 International : 001-260-357-0051 “Happiness is a Dog www.ecollar.com that Stays Home” sales@ecollar.com Copyright 2018 E-Collar Technologies, Inc. All Rights Reserved.
- Characteristics 1000 Series E-Fence System ..................- Contents ..............Thank you for purchasing the 1000 Series Wired E-Fence System from - Wall Mount Controller E-Collar Technologies, Inc. We have made every attempt to provide you ................- Collar Receiver with the most technologically advanced product using the most stringent ................
Operation Manual “Happiness is a Dog that Staus Home” • Employs Quick Charge Li-Polymer Batteries • Contact Point Tool • Test Light • AC adapter for Controller • USB Charging Cable for Collar Receiver 1000 Series E-Fence 1000 Series E-Fence...
Operation provide the operational condition of the Broken Wire Blinking Red Blinking '-' (Alarm On) wall mount transmitter. Power Failure Solid Red Blinking 'P' (Operating on Batteries) Solid Red Blinking 'b' Backup Batteries Low 1000 Series E-Fence 1000 Series E-Fence...
⑪ ⑫ ⑨ Power Connection : The power for the 1000 Series Controller is provided by a supplied UL certified 24 V, 400mA AC adapter. ⑩ USB Port : USB port provides charging the collar receiver, however any USB port Biothane Strap connected with 5V DC adaptor can be used.
The collar receiver will sense if the dog is attempting to run through, the system will administer the selected level of containment stimulation instantly. Important Note : The special features mentioned on this page are integrated into the collar receiver and work without any programming. 1000 Series E-Fence 1000 Series E-Fence...
B. Install the 3/4” contact points onto the bolt and tighten the contact points by rotating them clockwise with the contact point tool. * For dogs with either very short or very long or thick coats, please contact customer service for an appropriate size set of contact points. 1000 Series E-Fence 1000 Series E-Fence...
To Register for the 2 Year Warranty The collar should be adjusted to allow the “contact points” to have direct contact with the To register your 1000 Series , please select one of the following procedures dog’s skin. You should be able to fit a couple of fingers between the collar strap and your dog.
Need help?
Do you have a question about the 1000 Series and is the answer not in the manual?
Questions and answers
I received the collar and receiver for my 1000 series. I matched my new collar to my receiver. Status light is blue, lcd blinking dot. All is registering ok. No tone or shock to the collar. Is there some way I can reset