Additional Information; Troubleshooting - Sony DVP-S9000ES Operating Instructions Manual

Additional
Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
remedy the problem. Should any problem persist, consult
your nearest Sony dealer.
Power
The power is not turned on.
, Check that the mains lead is connected securely.
Picture
There is no picture.
, Check that the player is connected securely.
, The video connecting cord is damaged. Replace it
with a new one.
, Make sure you connect the player to the video
input connector on the TV. (page 10)
, Make sure you turn on the TV.
, Make sure you select the video input on the TV so
that you can view the pictures from the player.
, You have selected "PROGRESSIVE" in
"COMPONENT OUT" even though your TV
cannot accept the signal in progressive format. In
this case, set the SCAN SELECT switch on the back
panel of the player to "INTERLACE." Then set
"COMPONENT OUT" to "INTERLACE" after you
can see the TV screen correctly, and set SCAN
SELECT to "SELECTABLE."
Picture noise appears.
, Clean the disc.
, If the video signal from your SACD/DVD player
has to go through your VCR to get to your TV, the
copy-protection applied to some DVD programs
could affect picture quality. If you still experience
problems after checking your connections, please
try connecting your DVD player directly to your
TV's S-input, if your TV is equipped with this
input. (page 10)
, You have selected "PROGRESSIVE" in
"COMPONENT OUT" even though your TV
cannot accept the signal in progressive format. In
this case, set the SCAN SELECT switch on the back
panel of the player to "INTERLACE." Then set
"COMPONENT OUT" to "INTERLACE" after you
can see the TV screen correctly, and set SCAN
SELECT to "SELECTABLE."
, Even if your TV is compatible with progressive
format (525p) signals, the image may be affected
when you set "COMPONENT OUT" to
"PROGRESSIVE." In this case, set "COMPONENT
OUT" to "INTERLACE."
69