Sony DVP-S9000ES Operating Instructions Manual page 67

Controlling the TV
You can control your TV using the buttons below when
you set the TV/DVD switch to TV.
TV/DVD
switch
1 2 3
Number
4 5 6
buttons*
7 8 9
- 0
-/--*
You can
By pressing
?/1 Turn the TV on or off
TV/VIDEO Switch the TV's input source between
the TV and other input sources
VOL Adjust the volume of the TV
Select the channel (program position)
CH (RMT-D122E)
of the TV
PROG (RMT-D122O)
WIDE MODE Switch to or from the wide mode of a
wide TV.
Number buttons, -/-- Select the programme of the TV
and ENTER*
* RMT-D122O only
Notes
• Depending on the TV, you may not be able to control your TV
or to use some of the buttons above.
• If you use number buttons to select the TV's programme
position, press -/-- followed by the number buttons for two-
digit numbers. (RMT-D122O only)
Controlling AV receivers (amplifiers) with
the remote
?/1 (on/standby)
button
VOL
CH/PROG
TV/VIDEO
WIDE MODE
ENTER*
1
2
ENTER
Code numbers of controllable AV receivers
(amplifier)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
AV receiver (amplifier).
Manufacturer
Sony
Denon
Kenwood
Onkyo
Pioneer
Sansui
Technics
Yamaha
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote, the code number
may be reset to the default setting. Reset the appropriate code
number.
TV/DVD
switch
1 2 3
Number
4 5 6
7 8 9
buttons
-
0
Slide the TV/DVD switch to DVD.
Hold down ?/1, and enter your AV receiver's
manufacturer's code (see the table) using the
number buttons. Then release ?/1.
Code number
91 (default), 89
84, 85, 86
92, 93
81, 82, 83
99
87
97, 98
94, 95, 96
?/1 (on/standby)
button
67