Sony DVP-S9000ES Operating Instructions Manual page 11

If you connect the player to a monitor or
projector having component video input
connectors that conform to the output signals
from the COMPONENT VIDEO OUT (Y, P
P /C ) connectors on the player
R R
Connect the component via the COMPONENT VIDEO
OUT connectors using three video connecting cords (75
coaxial) (not supplied) of the same kind and length. You
will get a better picture.
SACD/DVD player
COMPONENT VIDEO OUT
Y P /C P /C
B B R R
Notes
• Refer to the instructions supplied with the component to be
connected.
• Do not connect this player to a video deck. If you do, noise
may appear in the picture.
VCR
SACD/DVD
player
• Depending on the TV or receiver (amplifier), sound distortion
may occur because the audio output level from this player is
high. In this case, set "AUDIO ATT" in "AUDIO SETUP" to
"ON" in the setup display. For details, see page 62.
• "PROGRESSIVE" does not work for PAL signals. Even if you
set "COMPONENT OUT" to "PROGRESSIVE," the output
signal is automatically switched to interlace format for PAL
signals.
/C ,
B B
Monitor or projector
with component video
input connectors
COMPONENT
VIDEO IN
Y
P /C
B B
P /C
R R
TV
Connect
directly
Setups for the player
Some setup adjustments are necessary for the player
depending on the TV or other components to be
connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 50.
• To connect the player to a normal TV
In the setup display, set "TV TYPE" in "SCREEN
SETUP" to "4:3 LETTER BOX" or "4:3 PAN SCAN."
For details, see page 56.
• To connect the player to a wide-screen TV
In the setup display, set "TV TYPE" in "SCREEN
SETUP" to "16:9" (default setting). For details, see page
56.
• To connect the player to a TV that accepts
progressive (525p) format signals
Connect the player to your TV using the COMPONENT
VIDEO OUT connectors, and set "COMPONENT OUT"
in "CUSTOM SETUP" to "PROGRESSIVE."
• If the color system of the TV is NTSC or PAL
The color system of the player is set to NTSC or PAL.
If the playback picture of the player does not appear on
the TV, change the color system of the player to the
same color system (PAL or NTSC) of your TV. To
change the color system, hold POWER down while
pressing X on the player. Wait until the power indicator
lights up in red. Then release X.
z
You can check the color system of the player
Press POWER on the player and then press @/1 on the remote.
The power indicator lights up in green. When "NTSC" appears
on the front panel display, the color system of the player is set to
NTSC. When "PAL" appears, the color system is set to PAL.
Note
If your player has the remote RMT-D122O, this player will
automatically output the NTSC signal or PAL signal in
accordance with the disc being played.
11