Selecting The Interface Assignments - Siemens SINAMICS G120D Getting Started Manual

Installation

3.9 Selecting the interface assignments

3.9 Selecting the interface assignments
Description
The converter offers different predefined assignments (macros) for its inputs and outputs and
the fieldbus interface.
Only the inputs and outputs whose functions change by selecting a specific assignment, are
shown on the following pages.
Procedure
● Wire up the converter according to the interface assignment most suitable for your
Further steps
● In the basic commissioning, select the default settings of the interfaces that best match
● If necessary, after the basic commissioning, adjust the function of the inputs or outputs
Fixed speeds
The default "Macro 1" is available only with Control Units CU240D-2 DP and CU240D-2 PN.
You must enable the safety function.
42
application.
your particular wiring.
and the fieldbus interface.
Getting Started, FW V4.5, A5E03404762A AB
Getting Started