Sony DVP-S570D Operating Instructions Manual page 66

Controlling Your TV or AV Receiver (Amplifier) with the Supplied Remote
Controlling the TV
You can control your TV using the buttons below. When
you set the TV/DVD switch to TV, you can also control
the number, 1/u and ENTER buttons.
TV/DVD
switch
1 2 3
4 5 6
Number
7 8 9
0
buttons
By pressing
You can
?/1 Turn the TV on or off
TV/VIDEO
Switch the TV's input source between
the TV and other input sources
VOL
Adjust the volume of the TV
CH Select the channel of the TV
Number buttons
Select the channel of the TV
and ENTER
Note
Depending on the TV, you may not be able to control your TV or
to use some of the buttons above.
Controlling AV receivers (amplifiers) with
the remote
TV/DVD
switch
1 2 3
Number 4 5 6
7 8 9
buttons
0
1
Slide the TV/DVD switch to DVD.
2
Hold down ?/1, and enter your AV receiver's
manufacturer's code (see the table) using the
number buttons. Then release ?/1.
66
Code numbers of controllable AV receivers
(amplifier)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
AV receiver (amplifier).
1/u
VOL Manufacturer
CH
Sony
TV/VIDEO
Denon
ENTER
Kenwood
Onkyo
Pioneer
Sansui
ENTER
Technics
Yamaha
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote, the code number
may be reset to the default setting. Reset the appropriate code
number.
Controlling the AV receiver (amplifier)
You can change the volume of the AV receiver (amplifier)
using AV VOL.
1/u
Notes
• Depending on the AV receiver (amplifier), you may not be able
to control your AV receiver (amplifier).
• You can control the AV receiver (amplifier) regardless of the
position of the TV/DVD switch.
Code number
91 (default), 89
84, 85, 86
92, 93
81, 82, 83
99
87
97, 98
94, 95, 96
1 2 3
4 5 6
7 8 9
0
AV VOL