Controlling Your Tv Or Av Amplifier (Receiver) With The Supplied Remote - Sony DVP-NS900V Operating Instructions Manual

Controlling Your TV or AV
Amplifier (Receiver) with
the Supplied Remote
By adjusting the remote signal, you can
control your TV with the supplied remote.
If you connect the player with an AV
amplifier (receiver), you can control the
volume with the supplied remote.
Check the model name of your remote
The supplied remote commander is different
depending on the player model. Check the
model name of your remote (RMT-D140E or
RMT-D140A) and follow the instructions
that correspond to your remote's model
name. Note that the buttons you can use for
operating your TV will differ according to the
model of your remote.
Notes
Depending on the units being connected, you may
not be able to control your TV or AV amplifier
(receiver) using some of the buttons below.
If you enter a new code number, the code number
previously entered will be erased.
When you replace the batteries of the remote, the
code number you have set may be reset to the default
setting. Set the appropriate code number again.
80
** RMT-D140A only
1
Model name
2
3
4
5
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your TV.
Controlling TVs with the remote
TV/DVD
switch
Number
buttons
-/--*
* RMT-D140E only
Slide the TV/DVD switch to TV.
While holding down [/1, press down on
the scroll key.
"TV P-1" appears in the LCD screen.
Release [/1.
Toggle the scroll key up or down to
select your TV's manufacturer's code
(see the table below).
Press down on the scroll key.
The manufacturer's code flashes and the
remote is set.
[/1
LCD screen
Scroll key
PROG* +/–
CH** +/–
VOL +/–
ENTER**
WIDE MODE
TV/VIDEO