Lamps - BMW G 650 GS 2010 Rider's Manual

If the fuses blow frequently,
8
have the electrical system
checked by an authorized spe-
82
cialized workshop, preferably a
BMW Motorrad retailer.
Installing fuse
z
Replace defective fuse with
fuse with required amperage.
An overview of the fuse as-
signment and the required
amperages is provided in the
chapter "Technical Data". The
numbers in the graphic match
the fuse numbers.
Close fuse cover.
Latch audibly engages.
Installing seat ( 39).

Lamps

Information
A defective bulb places
your safety at risk because
it is easier for other users to
oversee the motorcycle.
Replace defective bulbs as
soon as possible; always carry a
complete set of spare bulbs if
possible.
The bulb is pressurized and
can cause injury if dam-
aged.
Wear eye and hand protection
when replacing bulbs.
An overview of the bulb
types installed in your mo-
torcycle is provided in the chap-
ter "Technical Data".
Do not touch the glass of
new bulbs with your fin-
gers. For installation, use a clean,
dry cloth. Dirt deposits, in par-
ticular oil and grease, interfere
with heat radiation from the bulb.
Overheating and therefore short
service life of the bulbs are the
consequence.
Replacing low-beam and
high-beam bulb
If it is not standing firmly,
the motorcycle could topple
in the course of the operations
described below.
Make sure that the motorcycle is
steady on its stand.
Make sure ground is level and
firm and park motorcycle.
Switch off ignition.