Lamps - BMW F 800 R 2010 Rider's Manual

tween them. Adjust support
pin to match front suspension.
Use locating pins 3 to set front
wheel stand to desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Align two mounts 2 so that
front forks rest securely on
them.
Tighten adjusting screws 1.
Apply uniform pressure to push
front wheel stand down and
raise motorcycle.
OA
with center stand
If the motorcycle is raised
too far at the front the
center stand will lift clear of the
ground and the motorcycle could
topple to one side.
When raising the motorcycle,
make sure that the center stand
remains on the ground. Adjust
the height of the front wheel
stand if necessary.
Ensure motorcycle is standing
securely.

Lamps

General instructions
A bulb failure is signaled to you
in the multifunction display by a
warning indicator.
A defective bulb places
your safety at risk because
it is easier for other users to
oversee the motorcycle.
Replace defective bulbs as
soon as possible; always carry a
complete set of spare bulbs if
possible.
The bulb is pressurized and
can cause injury if dam-
aged.
Wear eye and hand protection
when replacing bulbs.
An overview of the bulb
types installed in your mo-
8
95
z