Table of Contents
Advertisement
Descriptions and possible confi gurations:
REFERENCE
RDS-20P
RDSC-20P *
SA-RDS
SAY1-RDS
RDS-20P-SA
RDSC-20P-SA *
* RDSC...type rail saws are provided with a support arm ignition control, it works only
if mounted on the support arm. If the rail saw is not mounted onto the support arm,
an automatic cut-off device stops the engine!
Main components
1 – Air fi lter spark plug cover
2 – Upper handle
3 – Safety guard (spark guard)
4 – Abrasive cutting disc (to be mounted)
5 – Transmission system side cover
6 – Foot
7 – Nameplate
8 – Support arm pin slot
9 – Silencer / muffl er
10 – (EasyStart) Decompression valve
11 – Combustion engine
12 – Abrasive cutting disc fi xing
RAIL SAW
•
•
(Ref. Fig. 1 page 5):
STANDARD
SUPPORT ARM
•
•
13 – Measure for petrol-oil mix
14 – 4mm Allen key for removing side cover
15 – Starter cord grip
16 – Multifunction spanner (torx + cut)
17 – Fuel tank cap
18 – Main ON/OFF switch
19 – Rear control handle
20 – Accelerator
21 – Safety lever
22 – Accelerator block
23 – Air valve control (starter)
SUPPORT ARM
FOR GIRDER RAILS
•
4
Advertisement
Table of Contents
