Cembre RDS-20P Operation And Maintenance Manual page 27

• Replacing the recoil spring
– Remove the starter pulley by unscrewing the central screw.
– Remove the recoil spring carefully by grasping it with grips.
– Lubricate the recoil spring with a few drops of oil and then reassemble the starter pulley
and tension the spring.
If the spring pops out during the assembly phase, it will have to be reassembled again
from the exterior towards the centre.
8.7) Transmission cooling system
The ventilation openings situated on the side cover allow the
suction of fresh air and its expulsion so that the transmission
system, including the belt, can be cooled.
After use and on a daily basis it is good practice
to check that these openings are perfectly cle-
an. If necessary, clean them with compressed
air or a soft brush.
The fi lter on the lower part of the cover
prevents cutting particles and debris being
conveyed inside the transmission area.
8.7.1) Cleaning the transmission fi lter
(spare part code: 6003655)
– Disassemble the side cover by removing
5 screws with the 4 mm Allen key supplied.
– Remove the fi lter and shake or clean it
with compressed air, to remove dirt.
– Relocate and reassemble the cover.
A clogged fi lter can cause abnormal
overheating of the belts resulting in pre-
mature wear.
In any case, depending on usage, the fi lter
will have to be replaced periodically with a
new one.
IMPORTANT: When cleaning the fi lter, clean also the inte-
rior of the transmission area and the two turbine wheels,
with compressed air; check the status of the drive belt,
if it is worn it's essential to replace it.
27
Air intake (suction) from outside
Side
cover
Transmission fi lter
Transmission fi lter