Cembre RDS-20P Operation And Maintenance Manual page 17

5.4) Mounting/dismounting the rail saw on the support arm
Before mounting the rail saw on the support arm, make sure that:
- the clamp (6) is fi rmly locked as described in § 5.1,
- the lever (7) is completely inserted
- the two knobs (8) are aligned at the same height.
1- Mount the rail saw on the support arm,
match the interface pin (11) with the slot of
the rail saw.
2- Push and rotate handle (1) tightening it fully.
To dismount the rail saw, completely loosen handle
(1) and remove it.
ONLY FOR RDSC-20P: The engine will be stopped by a cut-off device if the rail saw is
not mounted on the support arm (Ref. to § 3.2).
The fi gure shows the correct positioning of the rail saw on the support arm on both sides of the rail.
17
11
1
2
1
7
8
6